St. Anthony Airport Zoning Regulations

Regulations Respecting Zoning at St. Anthony Airport Whereas, pursuant to section 5.5 of the Aeronautics Act, a copy of the proposed Regulations respecting zoning at St. Anthony Airport, substantially in the form set out in the schedule hereto, was published in two successive issues of the Canada Gazette Part I on February 6th and 13th, 1993, and in two successive issues of The Northern Pen on March 16th and 23rd, 1993, and in two successive issues of Le Gaboteur on March 19th and 26th, 1993, and a reasonable opportunity was thereby afforded to interested persons to make representations to the Minister of Transport with respect thereto; Therefore, His Excellency the Governor General in Council, on the recommendation of the Minister of Transport, pursuant to section 5.4 of the Aeronautics Act, is pleased hereby to make the annexed Regulations respecting zoning at St. Anthony Airport. These Regulations may be cited as the St. Anthony Airport Zoning Regulations. In these Regulations, airport means the St. Anthony Airport, in the Electoral District of Strait of Belle Isle, in the Province of Newfoundland; (aéroport) airport reference point means the point described in Part I of the schedule; (point de repère de l’aéroport) approach surfaces means the imaginary inclined planes that extend upward and outward from each end of a strip, which planes are more particularly described in Part II of the schedule; (surfaces d’approche) outer surface means the imaginary plane located above and in the immediate vicinity of the airport, which plane is more particularly described in Part III of the schedule; (surface extérieure) strip means the rectangular portion of the landing area of the airport, including the runway, prepared for the take-off and landing of aircraft in a particular direction, which portion is more particularly described in Part IV of the schedule; (bande) transitional surfaces means the imaginary inclined planes that extend upward and outward from the lateral limits of a strip and its approach surfaces, which planes are more particularly described in Part V of the schedule. (surfaces de transition) For the purposes of these Regulations, the elevation of the airport reference point is 22 m above sea level. These Regulations apply to all land, including public road allowances, that is adjacent to or in the vicinity of the airport, which land is more particularly described as follows: the land within the outer limit described in Part VI of the schedule; and the land directly under those portions of the approach surfaces that extend beyond the said outer limit. No person shall erect or construct on any land to which these Regulations apply, any building, structure or object or any addition to any existing building, structure or object, the highest point of which will exceed in elevation at the location of that point the approach surfaces; the outer surface; or the transitional surfaces. No owner or lessee of any land to which these Regulations apply shall permit any part of that land to be used or developed in a manner that causes interference with any signals or communications to and from any aircraft or to and from any facilities used to provide services relating to aeronautics. Where an object of natural growth that is on any land to which these Regulations apply grows to a height that exceeds in elevation at the location of the object any of the surfaces referred to in section 4, the Minister may require that the owner or lessee of the land remove the excessive growth. No owner or lessee of any land to which these Regulations apply shall permit any part of that land to be used for the disposal of any waste that is edible by or attractive to birds. The airport reference point, shown on St. Anthony Airport Zoning Plan No. S-2211-2 dated March 30, 1990, is determined by measuring 610 m along the centre line of runway 11-29 from the westerly end of runway 11; THENCE measuring southerly, at right angles to the centre line of runway 11-29, 150 m to the airport reference point, said point having Newfoundland Transverse Mercator Projection Grid Coordinates of North 5,694,747.54 m and East 298,969.50 m. The approach surfaces, shown on St. Anthony Airport Zoning Plans Nos. S-2211-1, S-2211-2 and S-2211-3, dated March 30, 1990, are planes abutting each end of the strip associated with runway 11-29 and are described as follows: an inclined plane abutting the end of the strip associated with the approach to runway 11 having a ratio of 1 m measured vertically to 50 m measured horizontally rising to an imaginary horizontal line drawn at right angles to the projected centre line of the strip and distant 15 000 m measured horizontally from the end of the strip; the outer ends of the imaginary horizontal line being 2 400 m from the projected centre line; said imaginary horizontal line being 300 m above the elevation at the end of the strip; and an inclined plane abutting the end of the strip associated with the approach to runway 29 having a ratio of 1 m measured vertically to 50 m measured horizontally rising to an imaginary horizontal line drawn at right angles to the projected centre line of the strip and distant 15 000 m measured horizontally from the end of the strip; the outer ends of the imaginary horizontal line being 2 400 m from the projected centre line; said imaginary horizontal line being 300 m above the elevation at the end of the strip. The outer surface, shown on St. Anthony Airport Zoning Plan No. S-2211-2, dated March 30, 1990, is an imaginary plane established at a constant elevation of 45 m above the elevation of the airport reference point, except that, where that plane is less than 9 m above the surface of the ground, the outer surface is located at 9 m above the surface of the ground. The strip associated with runway 11-29, shown on St. Anthony Airport Zoning Plan No. S-2211-2 dated March 30, 1990, is 300 m in width, 150 m being on each side of the centre line of the runway, and 1 340 m in length. Each transitional surface, shown on St. Anthony Airport Zoning Plan No. S-2211-2, dated March 30, 1990, is an inclined plane rising at a ratio of 1 m measured vertically to 7 m measured horizontally at right angles to the centre line and projected centre line of the strip, extending upward and outward from the lateral limits of the strip and its approach surfaces to an intersection with the outer surface. The outer limit, shown on St. Anthony Airport Zoning Plan No. S-2211-2, dated March 30, 1990, is a circle with a radius of 4 000 m centred on the airport reference point.